AS/NZS 61439.1:2016

Abstract

Adopts IEC 61439-1, Ed. 2.0 (2011) to harmonize as far as practicable all rules and requirements of a general nature applicable to low-voltage switchgear and controlgear assemblies(ASSEMBLIES), in order to obtain uniformity of requirements and verification for ASSEMBLIES, and avoid the need for verification to other Standards.

Scope

NOTE 1 Throughout this standard, the term ASSEMBLY (see 3.1.1) is used for a low-voltage switchgear and controlgear assembly.
This part of the IEC 61439 series lays down the definitions and states the service conditions,
construction requirements, technical characteristics and verification requirements for lowvoltage switchgear and controlgear assemblies.
This standard cannot be used alone to specify an ASSEMBLY or used for a purpose of determining conformity. ASSEMBLIES shall comply with the relevant part of the IEC 61439 series; Parts 2 onwards.
This standard applies to low-voltage switchgear and controlgear assemblies (ASSEMBLIES) only
when required by the relevant ASSEMBLY standard as follows:
– ASSEMBLIES for which the rated voltage does not exceed 1 000 V in case of a.c. or
1 500 V in case of d.c.;
– stationary or movable ASSEMBLIES with or without enclosure;
– ASSEMBLIES intended for use in connection with the generation, transmission,
distribution and conversion of electric energy, and for the control of electric energy
consuming equipment;
– ASSEMBLIES designed for use under special service conditions, for example in ships
and in rail vehicles provided that the other relevant specific requirements are complied
with;
NOTE 2 Supplementary requirements for ASSEMBLIES in ships are covered by IEC 60092-302.
– ASSEMBLIES designed for electrical equipment of machines provided that the other
relevant specific requirements are complied with.
NOTE 3 Supplementary requirements for ASSEMBLIES forming part of a machine are covered by the IEC 60204 series.
This standard applies to all ASSEMBLIES whether they are designed, manufactured and verified
on a one-off basis or fully standardised and manufactured in quantity.
The manufacture and/or assembly may be carried out other than by the original manufacturer
(see 3.10.1).
This standard does not apply to individual devices and self-contained components, such as
motor starters, fuse switches, electronic equipment, etc. which will comply with the relevant product standards.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	EL-006
Supersedes	DR AS/NZS 61439.1:2014 AS/NZS 3439.1:2002