AS 2001.2.15-1989 (R2016)
AS 2001.2.15-1989 (R2016)
Methods of test for textiles Physical tests - Determination of thickness of textile fabrics
Standards Australia
Table of Contents
Abstract
Sets out methods for determination of the thickness of textile fabrics. Methods are given to determine the static and dynamic thicknesses of woven, non-woven, and knitted textile fabrics, and coated fabrics.
RECONFIRMATION NOTICE
Technical Committee TX-020 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 6 July 2016.
The following are represented on Technical Committee TX-020:
Ag Research
Australian Wool Processors Council
AWTA Textile Testing
Council of Textile and Fashion Industries of Australia
Drycleaning Institute of Australia
National Association of Testing Authorities Australia
RMIT University
The Textile Institute
Scope
This specification applies to small square weathertight hatches in the size range 650 mm ¦ 650 mm to 1275 mm ¦ 1275 mm. Four sizes are covered to a common basic design, with variations in securing and stiffening to suit the increases in size. Coaming height and thickness are not specified, as these will be determined by the position of the hatch and the requirements of the appropriate Statutory Authority and/or Classification Society.
The hatches are suitable for giving access to compartments other than those subjected to pressure. They are not suitable for use as escape hatches.
NOTE: When ordering hatches to this specification, the purchaser should provide the particulars listed in Appendix A.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 05/08/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 05/08/2016 |
| Committee | TX-020 |
| Supersedes |
|
