AS 2551-1982 (R2016)
AS 2551-1982 (R2016)
Steel sheet and strip - Cold-rolled, electrolytic zinc-coated
Standards Australia
Table of Contents
Abstract
Specifies three grades of cold-rolled unalloyed low carbon steel sheet produced on a continuous mill and zinc coated by an electrolytic process. Supplied as coil or cut lengths in thicknesses from 0.3 mm to 2 mm and in widths from 15 mm to 1250 mm.
RECONFIRMATION NOTICE
Technical Committee MT-001 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 23 October 2015.
The following are represented on Technical Committee MT-001:
Australasian Corrosion Association
Australian Building Codes Board
Australian Institute of Architects
Australian Steel Association
Australian Steel Institute
Bureau of Steel Manufacturers of Australia
Employers And Manufacturers Association
Materials Australia
New Zealand Heavy Engineering Research Association
Society of Automotive Engineers—Australasia
Scope
This standard specifies requirements for cold-rolled unalloyed low carbon steel sheet and strip produced on a continuous mill and zinc-coated by an electrolytic process, supplied as coil or cut lengths in thicknesses from 0.3 mm up to and including 2.0 mm and in widths from 15 mm up to and including 1250 mm.
Provision is made for three of the grades of coldrolled steel classified in terms of mechanical properties in accordance with AS 1595, produced with an exposed (E) finish, and for three classes of zinc coating according to the mass per unit area of the coating metal applied.
NOTE: Guidelines to purchasers on requirements that must be specified by the purchaser and those that must be agreed at the time of enquiry and/or order are given in Appendix A.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 27/05/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 27/05/2016 |
| Committee | MT-001 |
| Supersedes |
|
