AS 2662.2-1988

Corrosion inhibition (rust-proofing) - Motor vehicles Treatment of vehicles

Standards Australia

More info

1 - AS 2662.2-1988 CORROSION INHIBITION (RUST-PROOFING) - MOTOR VEHICLES - TREATMENT OF VEHICLES
4 - PREFACE
5 - CONTENTS
7 - FOREWORD
8 - 1 SCOPE.
8 - 2 APPLICATION.
8 - 3 REFERENCED DOCUMENT.
8 - 4 DEFINITIONS.
8 - 4.1 Corrosion inhibition product
8 - 4.2 Concealed area
8 - 4.3 Exposed area
8 - 5 GENERAL REQUIREMENTS.
8 - 5.1 Workpl ace.
8 - 5.2 Equi pment.
9 - 5.3 Data sheets.
9 - 6 PRETREATMENT.
12 - 7 ACCESS TO SURFACES TO BE TREATED.
12 - 7.1 General.
12 - 7.2 Vehicle at ground level.
23 - 7.3 Vehicle raised above ground level.
24 - 8 APPLICATION REQUIREMENTS.
24 - 8.1 Corrosion inhibition products.
24 - 8.2 Surfaces to be coated.
24 - 8.3 Minimum coating thickness.
24 - 9 APPLICATION.
24 - 9.1 General.
25 - 9.2 Vehicle at ground level.
31 - 9.3 Vehicle raised above ground level.
32 - 10 INSPECTION AND FINISHING.
32 - 10.1 Inspection.
32 - 10.2 Finishing.
33 - 11 MARKING.
33 - 12 RETREATMENT.
33 - 12.1 General.
33 - 12.2 Follow-up inspection.
34 - 12.3 Follow-up service.
34 - 12.4 Finishing after follow-up inspection and service
34 - 12.5 Marking after follow-up inspection and service
35 - APPENDIX A - SAMPLE DATA SHEETS
37 - 1. WORKSHOP.
37 - 2. EQUIPMENT.
37 - 3. PRETREATMENT.
38 - 4. DRILLING OF ACCESS HOLES.
38 - 5. RUST- PROOFING PRODUCTS.
38 - 5.1 Cavity product.
38 - 5.2 Underbody product.
38 - 6. APPLICATION.
38 - 6.1 Prohibition.
39 - 6.2 Surfaces between glassline and underbody.
39 - 6.3 Underbody surfaces.
40 - 7. FINISHING.
40 - 7.1 General.
40 - 7.2 Vehicle exterior.
40 - 7.3 Vehicle interior.
40 - 7.4 Marking.
41 - 8. FOLLOW-UP TREATMENT FOR WARRANTY.
41 - 8.1 Inspection.
42 - 8.2 Re-treatment.
42 - 8.3 Finishing.
42 - 8.4 Re-marking.

Abstract

Sets out procedures which are to be followed when applying corrosion inhibition products (commonly known as rust-proofing products) to motor vehicles. The Standard describes pretreatment procedures, possible accesses to surfaces that are to be treated, application requirements, inspection and finishing requirements as well as retreatment procedures if the conditions of contract require that the vehicle be periodically retreated. Further, the Standard includes sample 'Data Sheets' which are required to be prepared by the rustproofer before the vehicle is treated.