AS 1746-1991 (R2016)

Table of Contents

Abstract

Sets out requirements and tests necessary for homogeneous bare electrical conductors for overhead power transmission, and constructed of hard-drawn copper wires. A range of wire sizes and their properties are provided.
RECONFIRMATION NOTICE
Technical Committee EL-010 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 18 November 2015.
The following are represented on Technical Committee EL-010:
Australian Industry Group
Electricity Engineers Association (New Zealand)
Energy Networks Association

Scope

This Standard specifies requirements and tests for homogeneous bare electrical conductors for overhead power transmission, and constructed of hard-drawn copper wires.
NOTES:
1 Appendix A gives methods to calculate conductor properties.
2 Appendix B gives the coefficient of linear expansion and the theoretical basis for the calculation of modulus of elasticity.
3 Appendix C lists information which should be supplied with enquiries and orders for conductors.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 27/05/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 27/05/2016
Pages
ISBN
Committee	EL-010
Supersedes	DR 90062 AS 1746-1975