AS 2341.7-1993 (R2013)

Table of Contents

1 -  AS 2341.7-1993 METHODS OF TESTING BITUMEN AND RELATED ROADMAKING PRODUCTS - DETERMINATION OF DENSITY USING A DENSITY BOTTLE
1 -  1 SCOPE
1 -  2 REFERENCED DOCUMENTS
1 -  3 APPARATUS
2 -  4 CALIBRATION
2 -  5 PROCEDURE
2 -  5.1 Total filling method
2 -  5.2 Partial filling method
3 -  6 CALCULATION AND EXPRESSION OF RESULTS
3 -  6.1 Total filling method
3 -  6.2 Partial filling method
3 -  7 PRECISION
3 -  8 REPORT

Abstract

Sets out procedures for the determination of density of bituminous materials using a density bottle.

RECONFIRMATION NOTICE
Technical Committee CH-025 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 8 April 2013.
The following are represented on Technical Committee CH-025:

Australian Road Research Board
Australian Asphalt Pavement Association
Australian Chamber of Commerce and Industry
Australian Institute of Petroleum
AUSTROADS
Engineers Australia
National Association of Testing Authorities Australia
Roading New Zealand
Transit New Zealand


To view or download a copy of the reconfirmation notice please go to the reconfirmation link near the top of this page.

Scope

This Standard sets out two procedures for the determination of density of bituminous materials using a density bottle. These procedures are known as the total filling method and the partial filling method. The total filling method is applicable to materials which are sufficiently fluid at 25¦C to allow the bottle stopper to be pressed into position when the bottle is filled. The partial filling method is applicable to materials which are too viscous for the total filling method. The two methods cover all bitumen and related products for roadmaking.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 26-07-2013
Pages
ISBN
Committee	CH-025
Supersedes	AS 2341.7-1982 DR 89162