AS 2369.2-1993 (R2013)

Table of Contents

1 -  AS 2369.2-1993 MATERIALS FOR SOLAR COLLECTORS FOR SWIMMING POOL HEATING - FLEXIBLE OR PLASTICIZED POLYVINYL CHLORIDE
6 -  1 SCOPE
6 -  2 REFERENCED DOCUMENTS
6 -  3 GENERAL
7 -  4 FORMULATION
7 -  5 TEST PIECES
7 -  6 REQUIREMENTS
7 -  7 DETERMINATION OF PROPERTIES OF THE MATERIAL
7 -  7.1 Hardness
7 -  7.2 Tensile strength
7 -  7.3 Ultimate elongation
7 -  7.4 Burst pressure at ambient temperature
7 -  7.5 Burst pressure at 45°C
7 -  7.6 Pressure integrity
7 -  7.7 Plasticizer compatibility
7 -  8 TESTS ON MATERIAL AS MANUFACTURED
8 -  9 TESTS ON MATERIAL AFTER ACCELERATED WEATHERING
8 -  10 TESTS ON MATERIAL AFTER EXPOSURE TO CHEMICALS
9 -  11 MARKING

Abstract

Sets out a specification for properties for polyvinyl chloride (PVC) used in the manufacture of unglazed collectors intended for solar heating of swimming pools.

RECONFIRMATION NOTICE
Technical Committee CS-028 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 1 May 2013.
The following are represented on Technical Committee CS-028:

Australian Building Codes Board
Australian Chamber of Commerce and Industry
Australian Industry Group
Australian Institute of Refrigeration Air Conditioning and Heating
Australian Solar Cooling Interest Group
Australian Solar Council
Clean Energy Council
Consumer Electronics Suppliers Association
CSIRO
Department of Climate Change and Energy Efficiency
Electrical Compliance Testing Association
Gas Appliance Manufacturers Association of Australia
James Cook University
Office of the Renewable Energy Regulator
Sustainability Victoria
The University of New South Wales
University of South Australia



To view or download a copy of the reconfirmation notice please go to the reconfirmation link near the top of this page.

Scope

This Standard specifies the properties of polyvinyl chloride (PVC) used in the manufacture of unglazed collectors intended for solar heating of swimming pools. The Standard is applicable to products used for collectors which take the form of flexible tubing, or absorber strips comprising water passages joined by a web. The requirements of this Standard are based on the assumption that the solar pool heating systems in which these materials are used will be installed in accordance with AS 3634, and that the pool water will be maintained in accordance with AS 3633.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 26-07-2013
Pages
ISBN
Committee	CS-028
Supersedes	AS 2369.2(Int)-1990