Paints and related materials - Methods of test - Determination of dry film thickness on metallic substrates - Non-destructive methods
Standards Australia
Specifies non-destructive test methods for determining the dry film thickness on metallic substrates using magnetic torsion pull-off instruments, magnetic induction instruments and eddy current instruments.
RECONFIRMATION NOTICE
Technical Committee CH-003 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 30 May 2013.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 26 August 2013.
The following are represented on Technical Committee CH-003:
Australasian Corrosion Association
Australian Paint Approval Scheme
Australian Paint Manufactures' Federation
Australian Pipeline Industry Association
Institution of Professional Engineers New Zealand
Master Painters New Zealand Association
Water Corporation Western Australia
This Standard sets out a general procedure for determining the thickness of non-magnetic coatings on steel or other metallic substrates using non-destructive testing techniques within the laboratory. It is intended for use with coatings which produce films that are firm and not subject to indentation by the instruments used. The coating thickness measurements may be obtained with magnetic torsional pull-off gauges, magnetic induction or eddy current type instruments. The method is not applicable to coatings of less than 20 µm thickness.
NOTES:
1 Site testing procedures are described in AS 3894.3.
2 Direct magnetic pull-off gauges are not covered by this Standard.
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 18/09/2013 This standard has been reconfirmed in Australia in 2013 and remains current in New Zealand. Reconfirmation Notice 18/09/2013 |
| Committee | CH-003 |
| Under Revision |
|
| Supersedes |
|
