AS/NZS 3750.4:1994 (R2013)

Table of Contents

Abstract

Provides requirements for single component bitumen paints intended for the short-term protection of iron and steel against atmospheric corrosion.

RECONFIRMATION NOTICE
Technical Committee CH-003 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 30 May 2013.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 26 August 2013.
The following are represented on Technical Committee CH-003:

Australasian Corrosion Association
Australian Paint Approval Scheme
Australian Paint Manufactures' Federation
Australian Pipeline Industry Association
Institution of Professional Engineers New Zealand
Master Painters New Zealand Association
Water Corporation Western Australia

Scope

This Standard sets out requirements for single-component paints incorporating bitumen, which is derived from petroleum crudes and intended for the short-term protection of iron and steel against atmospheric corrosion. The paints should be applied by brush, roller or spray. The Standard deals with coatings that are surface-dry within
10 h, and may be overcoated after 24 h. Paint described in this Standard is listed as Paint Type 22 in AS 2312 and may be used in systems SP2-A and SP2-B.
The paint is intended as a single or two-coat system on steel.
NOTES:
1 Appendix A provides recommendations on information which should be provided by the purchaser at the time of enquiry or order.
2 Additional information on the use and application of bitumen paints is given in Appendix B.
3 Alternative means for determining compliance with this Standard are given in Appendix C.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmation Notice 16-09-2013
Pages
ISBN
Committee	CH-003
Supersedes	DR 93015