AS 3731.1-1995

Table of Contents

1 -  AS 3731.1-1995 STATIONARY BATTERIES-NICKEL-CADMIUM - VENTED TYPE
4 -  PREFACE
5 -  CONTENTS
7 -  SECTION 1: GENERAL
7 -  1.1 Scope
7 -  1.2 Normative references
7 -  1.3 Definitions
8 -  1.3.1 Vented cell
8 -  1.3.2 Nominal vol tage
8 -  1.3.3 Rated capaci ty
8 -  1.4 Measuring instruments
8 -  1.4.1 Voltage measurement
8 -  1.4.2 Current measurement
8 -  1.4.3 Temperature measurement
8 -  1.4.4 Time measurement
9 -  SECTION 2: DESIGNATION AND MARKING
9 -  2.1 Cel l designation
9 -  2.2 Cel l termination
9 -  2.3 Marking
10 -  SECTION 3: DIMENSIONS
10 -  3.1 Dimensions
12 -  SECTION 4: ELECTRICAL TESTS
12 -  4.1 Charging procedure for test purposes
12 -  4.2 Discharge performance
12 -  4.2.1 Discharge performance at +20 ° C
13 -  4.2.2 Discharge performance at -18 ° C
13 -  4.3 Charge retention
14 -  4.4 Endurance
14 -  4.4.1 Endurance in cycles
15 -  4.4.2 Permanent charge endurance
15 -  4.5 Charge acceptance at constant voltage
15 -  4.6 Overcharge
15 -  4.7 Vent operation
15 -  4.8 Storage
15 -  SECTION 5: MECHANICAL TESTS
15 -  5.1 Mechanical test
16 -  SECTION 6: CONDITIONS FOR APPROVAL AND ACCEPTANCE
16 -  6.1 Type approval
17 -  6.2 Batch acceptance
18 -  Amendment 1
20 -  Amendment 2

Abstract

Specifies requirements and tests for vented nickel-cadmium rechargeable batteries. Technically identical with and reproduced from IEC 623:1990, including Amendment No.1:1992 and Amendment No.2:1992.

Scope

This international standard specifies tests and requirements for vented nickel-cadmium prismatic secondary single cells.
NOTE - In this context, "prismatic" refers to cells having rectangular sides and base.
When there exists an IEC standard specifying test conditions and requirements for cells used in special applications and which is in conflict with this standard, the former shall take precedence.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	EL-005
Supersedes	AS 3731.1-1989