AS 4362.2-1996 (R2015)
AS 4362.2-1996 (R2015)
High-voltage test techniques for low-voltage equipment Test equipment
Standards Australia
Abstract
Applies to test equipment used for dielectric tests on low-voltage equipment with direct, alternating or impulse voltage and impulse current on equipment having a rated voltage of not more than 1 kV a.c. or 1.5 kV d.c. This Standard is identical with and reproduced from IEC 1180-2:1994.
RECONFIRMATION NOTICE
Technical Committee EL-007 has reviewed the content of this publication and in
accordance with Standards Australia procedures for reconfirmation, it has been
determined that the publication is still valid and does not require change.
Reconfirmed documents cannot be amended, but may be formally revised and a new
edition published.
Certain documents referenced in the publication may have been amended since the
original date of publication. Users are advised to ensure that they are using the latest
versions of such documents as appropriate, unless advised otherwise in this
Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 18 May 2015.
Reconfirmed documents cannot be amended, but may be formally revised and a new
edition published.
The following are represented on Technical Committee EL-007:
Ausgrid
Australian Industry Group
Energy Networks Association
Engineers Australia
The University of New South Wales
Scope
This part of IEC 1180 is applicable to the test equipment used for dielectric tests on low-voltage equipment. It covers tests with direct, alternating or impulse voltage, impulse current, and tests with a combination of impulse voltage and impulse current. Verification procedures necessary for ensuring that the dielectric tests comply with the voltage, or current, requirements stated in part 1 of this standard in shape and magnitude are stated.
The test equipment comprises a voltage and/or current generator and a measuring system. This standard covers test equipment in which the measuring system is protected against external interference and coupling by appropriate screening, for example a continuous conducting shield. Therefore, simple comparison tests are sufficient to ensure valid results.
Test equipment having measuring systems composed of non-screened components and/or connected by long leads is not covered in this standard. In this case guidance can be obtained from IEC 60-2 keeping in mind the less stringent requirements of this standard.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 18/05/2015. This standard as been reconfirmed in Australia in 2015 and remains current in New Zealand. Reconfirmation Notice 18/05/2015 |
| Committee | EL-007 |
| Supersedes |
|
