AS/NZS 1365:1996 (R2016)

Table of Contents

Abstract

Specifies dimensional tolerances for flat-rolled steels in the form of wide slabs, plate and floorplate rolled on a reversing mill, hot-rolled plate, floorplate, sheet and strip rolled on a continuous mill and cold-rolled sheet and strip. It does not apply to stainless, high alloy and quenched and tempered steels. Two classes of tolerance (A and B) are specified; Class B being the more stringent.
RECONFIRMATION NOTICE
Technical Committee MT-001 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 29 October 2015.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 4 November 2016.
The following are represented on Technical Committee MT-001:
Australasian Corrosion Association
Australian Building Codes Board
Australian Institute of Architects
Australian Steel Association
Australian Steel Institute
Bureau of Steel Manufacturers of Australia
Employers And Manufacturers Association
Materials Australia
New Zealand Heavy Engineering Research Association
Society of Automotive Engineers- Australasia

Scope

This Standard specifies dimensional tolerances for flat-rolled steels (uncoated, metallic-coated or rganic-coated), other than stainless, high alloy and quenched and tempered steels, as follows:
(a) Wide slabs.
(b) Plate and floorplate rolled on a reversing mill.
(c) Hot-rolled plate, floorplate, sheet and strip rolled on a continuous mill.
(d) Cold-rolled sheet and strip.
For coated products, thickness tolerances apply to the base metal only.
NOTE: Widths and thicknesses given in tables do not necessarily indicate availability in Australia or New Zealand, and enquiries in this regard should be directed to suppliers.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 23/12/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 23/12/2016
Pages
ISBN
Committee	MT-001
Supersedes	AS 1365-1986 DR 94446