AS/NZS 1580.204.1:1998 (R2013)

Table of Contents

1 -  AS/NZS 1580.204.1:1998 PAINTS AND RELATED MATERIALS-METHODS OF TEST - FINENESS OF GRIND
1 -  PREFACE
1 -  METHOD
1 -  1 SCOPE
1 -  2 REFERENCED DOCUMENTS
1 -  3 DEFINITIONS
1 -  3.1 Fineness of grind
2 -  3.2 Working gauge block
2 -  4 PRINCIPLE
2 -  5 APPARATUS
2 -  5.1 Gauge block
2 -  5.2 Scraper
2 -  6 SAMPLE AND SAMPLE PREPARATION
2 -  7 PROCEDURE
2 -  7.1 General
2 -  7.2 Determination
3 -  8 PRECISION
4 -  9 REPORT
6 -  APPENDIX A - CALIBRATION OF A WORKING GAUGE BLOCK
6 -  A1 SCOPE
6 -  A2 PROCEDURE
7 -  APPENDIX B - DESCRIPTION OF A REFERENCE GAUGE BLOCK AND SCRAPER FOR MEASUREMENT OF FINENESS OF GRIND
7 -  B1 SCOPE
7 -  B2 APPARATUS
7 -  B2.1 Gauge block
8 -  B2.2 Scraper
12 -  APPENDIX C - GAUGES MARKED IN NON-ISO UNITS

Abstract

RECONFIRMATION NOTICE
Technical Committee CH-003 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 30 May 2013.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 26 August 2013.
The following are represented on Technical Committee CH-003:

Australasian Corrosion Association
Australian Paint Approval Scheme
Australian Paint Manufactures' Federation
Australian Pipeline Industry Association
Institution of Professional Engineers New Zealand
Master Painters New Zealand Association
Water Corporation Western Australia

Scope

This Standard describes a procedure for determining the fineness of grind of paints and related materials.
The method is applicable to most types of paints and related materials, but care is required to obtain reliable results when the fineness of grind is less than 20 mm. Particular caution is required when interpreting readings of less than 10 mm.
NOTE: This method is designed for use by operators with good eyesight or corrected vision.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmation Notice 19-09-2013
Pages
ISBN
Committee	CH-003
Supersedes	AS 1580.204.1-1990 DR 96256