AS 1774.4.3-1998 (R2013)

Table of Contents

1 -  AS 1774.4.3-1998 REFRACTORIES AND REFRACTORY MATERIALS - PHYSICAL TEST METHODS - PREPARATION OF TEST PIECES - UNSHAPED REFRA
1 -  PREFACE
1 -  CONTENTS
2 -  METHOD
2 -  1 SCOPE
2 -  2 REFERENCED DOCUMENTS
2 -  3 DEFINITIONS
2 -  4 PRINCIPLE
2 -  5 SAFETY
2 -  6 APPARATUS
2 -  6.1 Castable refractories
2 -  6.2 Gunning refractories
3 -  6.3 Mouldables
3 -  6.4 Cutting saw
3 -  6.5 Drying oven
3 -  7 PROCEDURE
3 -  7.1 Casting
4 -  7.2 Gunning
4 -  7.3 Curing and drying
4 -  7.4 Mouldables
4 -  8 REPORT

Abstract

Describes a procedure for the preparation of test pieces on site from all types of unshaped refractory materials.

RECONFIRMATION NOTICE
Technical Committee MN-007 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 4 April 2013.
The following are represented on Technical Committee MN-007:

Australian Institute of Mining and Metallurgy
Australian Ceramic Society
Bureau of Steel Manufacturers of Australia
Cement Industry Federation
CSIRO Manufacturing & Materials Technology
Institute of Refractories Engineers
Refractories Manufacturers Association of Australia
The University of New South Wales


To view or download a copy of the reconfirmation notice please go to the reconfirmation link near the top of this page.

Scope

This Standard describes the procedure for the preparation of test blocks on site from all types of unshaped refractory materials.
NOTE: The values obtained from test pieces prepared using this method may not correspond with those obtained from test pieces of the same material prepared using test laboratory methods.
Where the physical dimensions of entry to the gunning site will not permit samples to be prepared adjacent to this site, the sample size may be adjusted.
NOTE: There is a growing practice of taking cored samples from cured installed lining. In such cases, the curing and drying requirements of this Standard are applicable.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 16-07-2013
Pages
ISBN
Committee	MN-007
Supersedes	DR 96349