AS/NZS 1595:1998 (R2016)
AS/NZS 1595:1998 (R2016)
Cold-rolled, unalloyed, steel sheet and strip
Standards Australia
Table of Contents
Abstract
Specifies requirements for cold-rolled, unalloyed, steel sheet and strip, supplied as both coil and cut lengths to chemical composition only, or to strength, hardness or formability requirements. It also specifies two surface finishes (lustre and matt) and three levels of surface quality.
RECONFIRMATION NOTICE
Technical Committee MT-001 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 29 October 2015.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 18 May 2016.
The following are represented on Technical Committee MT-001:
Australasian Corrosion Association
Australian Building Codes Board
Australian Institute of Architects
Australian Steel Association
Australian Steel Institute
Bureau of Steel Manufacturers of Australia
Employers And Manufacturers Association
Materials Australia
New Zealand Heavy Engineering Research Association
Society of Automotive Engineers—Australasia
Scope
This Standard specifies requirements for cold-rolled, unalloyed, steel sheet and strip, supplied as both coil and cut lengths to chemical composition only, or to strength, hardness or formability requirements.
Provision is made for three temper-rolled grades produced to hardness requirements, five grades to strength requirements (including one weather resistant grade) and five grades to formability requirements. In addition, two surface finishes are specified, and provision is made for three levels of surface quality.
NOTES:
1 Advice and recommendations on information to be supplied by the purchaser at the time of enquiry and order are contained in the purchasing guidelines set out in Appendix A.
2 Alternative means for demonstrating compliance with this Standard are given in Appendix B.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 10/06/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 10/06/2016 |
| Committee | MT-001 |
| Supersedes |
|
