AS 4391-1999 (R2016)

Table of Contents

Abstract

Sets out a hot smoke test methodology by means of which a specified quantity of smoke may be generated, at a safe temperature, within a building. Test apparatus, procedures and safety requirements for the hot smoke testing of smoke management systems are detailed. The size of test fire is selected to generate the required quantity of smoke at a safe temperature.
RECONFIRMATION NOTICE
Technical Committee ME-062 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 13 October 2015.
The following are represented on Technical Committee ME-062:
Air Conditioning & Mechanical Contractors Association
Australasian Fire and Emergency Service Authorities Council
Australian Building Codes Board
Australian Industry Group
Australian Institute of Refrigeration Air Conditioning and Heating
Chartered Institution of Building Services Engineers
Climate Control Companies Association
Consumer Electronics Suppliers Association
Department of Health and Human Services (TAS)
Engineers Australia
Facility Management Association of Australia
Institute of Refrigeration Heating & AirConditioning Engineers of New Zealand
NATSPEC
The Insulation Contractors Association of Australia NSW
Victorian Building Authority

Scope

This Standard sets out the means by which a specified quantity of smoke may be generated, at a safe temperature, within a building. It details test apparatus, procedures and safety requirements for the hot smoke testing of smoke management systems. The size of test fire is selected to generate the required quantity of smoke at a safe temperature.

C1.1 The size of test fires specified in this Standard varies from areas of 0.03 m2to 2 m2. It is, therefore, possible to apply a hot plume in a compartment of any size without causing damage. It is recommended that a hot smoke test be utilized whenever a smoke test is considered necessary.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 27/05/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 27/05/2016
Pages
ISBN
Committee	ME-062
Supersedes	AS/NZS 4391(Int):1996 DR 98305 CP