AS/NZS 4548.3:1999 (R2013)

Table of Contents

Abstract

Provides a guide to the features and typical characteristics of long-life textured coatings, which do not utilize aggregates, intended for exterior or interior use on concrete and masonry, when applied by airless spray, hopper spray or roller in accordance with the manufacturer's instructions.

RECONFIRMATION NOTICE
Technical Committee CH-003 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 30 May 2013.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 26 August 2013.
The following are represented on Technical Committee CH-003:

Australasian Corrosion Association
Australian Paint Approval Scheme
Australian Paint Manufactures' Federation
Australian Pipeline Industry Association
Institution of Professional Engineers New Zealand
Master Painters New Zealand Association
Water Corporation Western Australia

Scope

This Standard provides a guide to the features and typical characteristics of long-life textured coatings, which do not utilize aggregates, intended for exterior or interior use on concrete and masonry, when applied by airless spray, hopper spray or roller in accordance with the manufacturer's instructions.
Paints covered by this Standard are classified as paint Type 38 of AS 2311 and correspond generally to Australian Paint Approval Scheme specification Type 3 of GPC-C-117.
Non-aggregate, low to medium profile textured latex coatings are selected for aesthetic purposes to provide attractive decorative profiles, according to the application technique used. Application may be by textured roller, airless spray or hopper spray, depending upon the profile required, and will achieve a spreading rate of
1.0-2.0 m2/L (1.0-0.5 L/m2).
This type of coating is generally specified in a system including a topcoat of material as characterized by
AS/NZS 4548.2 where maximum resistance to moisture ingress and dirt pick-up is required.
These coatings are not intended for use on horizontal surfaces where water ponding is possible. They are normally specified in systems that may have a sealer and multiple coats.
NOTES:
1 AS/NZS 4548.5 provides a test which may be used to check the cure of concrete and masonry surfaces before applying the sealer.
2 Appendix A provides guidance on the use of long-life coatings for concrete and masonry.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmation Notice 13-09-2013
Pages
ISBN
Committee	CH-003
Supersedes	DR 96392