AS/NZS 4667:2000 (R2016)

Table of Contents

Abstract

Sets out the quality requirements for cut sizes of flat, transparent, clear ordinary annealed, tinted heat-absorbing, patterned and wired glass for general glazing and/or further processing.
RECONFIRMATION NOTICE
Technical Committee BD-007 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 12 May 2016.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 4 November 2016.
The following are represented on Technical Committee BD-007:
Australian Building Codes Board
Australian Chamber of Commerce and Industry
Australian Glass & Glazing Association
Australian Industry Group
Australian Shop and Office Fitting Industry Association
Australian Window Association
Building Research Association of New Zealand
Glass Association of New Zealand
Housing Industry Association
Master Builders Australia
Monash University
The University of New South Wales
The University of Sydney
Window and Door Industry Council
Window Association of New Zealand
Window Film Association of Australia & New Zealand

Scope

This Standard specifies requirements for the following:
(a) Cut sizes of flat, clear ordinary annealed and tinted heat-absorbing glass with glossy, apparently plane and smooth surface, which are used for general and architectural glazing, or similar.
(b) Cut sizes of flat, clear ordinary annealed and tinted heat-absorbing processing glass used for Grade A safety requirements (i.e. toughened or laminated).
(c) Cut sizes of ordinary annealed, patterned and wired glass used in decorative and general glazing applications.
(d) Cut sizes of wired glass used for Grade B safety and general glazing applications.
(e) Processed laminated and toughened glass.
NOTE:
1 This Standard is not intended to restrict the use of materials or methods of test not specified herein, where such materials or methods of test can be demonstrated to be the equal to, or superior to, those specified.
2 This Standard is not intended to cover glass for mirrors.
3 All other quality requirements not covered in the Standard, such as delamination of laminated glass, should be agreed between the manufacturer and the customer.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 16/12/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 16/12/2016
Pages
ISBN
Committee	BD-007
Supersedes	DR 98492