AS/NZS 4765:2017
AS/NZS 4765:2017
Modified PVC (PVC-M) pipes for pressure applications
Standards Australia
Abstract
This Standard specifies requirements for pipes, integral joints and post-formed bends of PVC-M for the conveyance of water and wastewater under pressure. The pipes are intended for installation below ground, and above ground where they are not exposed to direct sunlight.
Scope
This Standard specifies requirements for pipes, integral joints and post-formed bends of PVC-M for the conveyance of water and wastewater under pressure. The pipes are intended for installation below ground, and above ground where they are not exposed to direct sunlight.
Appendix G sets out additional requirements for pipes classed as best environmental practice PVC pressure pipe.
NOTES:
1 Relevant installation requirements for pipe systems, including PVC-M pressure pipes manufactured to this Standard and the associated fittings are covered by AS/NZS 2032, AS/NZS 2566.2 and the AS/NZS 3500 series, as applicable.
2 If the intention is to use pipes complying with this Standard for the conveyance of fluids other than water, the manufacturer should be consulted.
3 Two series of pipes are specified (see the Foreword in this Standard).
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| Committee | PL-021 |
| Supersedes |
|
