AS/NZS 62013.2:2001

Table of Contents

1 -  AS/NZS 62013.2:2001 CAPLIGHTS FOR USE IN MINES SUSCEPTIBLE TO FIREDAMP = PERFORMANCE ADN OTHER SAFETY-RELATED MATTERS
4 -  PREFACE
5 -  CONTENTS
6 -  1 Scope
6 -  2 Normative references
6 -  3 Definitions
7 -  3.1 evaluation area
7 -  3.2 useful working period
7 -  3.3 average illumination, Eave
7 -  3.4 minimum illumination, Emin
7 -  3.5 maximum illumination, Emax
7 -  3.6 cut-off angle
7 -  4 General
7 -  5 Light output
7 -  5.1 Light sources
8 -  5.2 Light source holder
8 -  5.3 Illumination cut-off angle
8 -  5.4 Illuminance of main source
8 -  5.5 Auxiliary light source
8 -  5.6 Focus
8 -  6 Reliability
8 -  6.1 Lamp life
8 -  6.2 Battery life (charge/ discharge cycles)
8 -  6.3 Caplight useful working period
9 -  6.4 Durability
9 -  6.4.1 Fasteners and connectors
9 -  6.4.2 Resistance to abrasion
9 -  6.4.3 Operability after mechanical tests
9 -  7 Ergonomics
9 -  7.1 Mass
9 -  7. 2 Ease of operation
9 -  7.3 Maintainability
9 -  8 Type tests
9 -  8.1 Illumination cut- off angle
10 -  8.2 Verification of the declared useful working period
10 -  8.3 Lamp life
11 -  9 Documentation
11 -  10 Marking
12 -  Annex A - Examples of the manufacturer’s instructions on user routine testing
12 -  A.1 Preparatory requirements
12 -  A.2 Evaluation procedure
13 -  A.3 Pass requirement
13 -  A.4 Specimen test report

Abstract

Details those performance and other safety features of caplights for use in mines susceptible to firedamp that are not covered in AS/NZS 62013.1 but which are nevertheless important for the safety and working conditions of the user. It may be applied for use in mines not likely to be endangered by firedamp. This Standard is identical to and has been reproduced from IEC 62013-2:2001.

Scope

This part of IEC 62013 details those performance and other safety features not covered in IEC 62013-1, but which are nevertheless important for the safety and working conditions of the user. It may also be applied to caplights for use in mines not likely to be endangered by firedamp. When this part of the standard is used as a "stand-alone" document for non-gassy mines, any relevent constructional requirements should be the subject of agreement between the supplier and the user and, where possible, be as described in IEC 62013-1.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	EL-023
Under Revision	DR 06460 CP
Supersedes	DR 01050-01051 CP DR 01051 CP