AS 3952-2002 (R2015)
AS 3952-2002 (R2015)
Water supply - Spring hydrant valve for waterworks purposes
Standards Australia
Abstract
Specifies requirements for flanged ductile cast iron spring hydrant valves with resilient seat for waterworks purposes. This Standard is applicable to Class 16 valves of nominal size DN 80 with either DN 80 or DN 100 flange with a maximum working temperature of 60°C. The valve is intended for use with potable water and is operated by means of the attachment of a standpipe.
RECONFIRMATION NOTICE
Technical Committee WS-022 has reviewed the content of this publication and in
accordance with Standards Australia procedures for reconfirmation, it has been determined
that the publication is still valid and does not require change.
Reconfirmed documents cannot be amended, but may be formally revised and a new edition
published.
Certain documents referenced in the publication may have been amended since the original
date of publication. Users are advised to ensure that they are using the latest versions of
such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 3 February 2015.
Reconfirmed documents cannot be amended, but may be formally revised and a new edition
published.
The following are represented on Technical Committee WS-022:
Australian Chamber of Commerce and Industry
Australian Industry Group
Australian Stainless Steel Development Association
Australian Water Association
Engineers Australia
Institute of Instrumentation, Control & Automation
Plastics Industry Pipe Association of Australia
Plumbing Products Industry Group
Water Industry Alliance
Water Services Association of Australia
Scope
This Standard specifies requirements for flanged ductile cast iron spring hydrant valves with resilient seat for waterworks purposes. This Standard is applicable to Class 16 valves of nominal size DN 80 with either DN 80 or DN 100 flange with a maximum working temperature of 60°C. The valve is intended for use with potable water and is operated by means of the attachment of a standpipe.The life of the valve is intended to be a minimum of 50 years, and the design criteria should be based on this requirement.
Means for demonstrating compliance with this Standard are given in Appendix A.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 23/04/2015. This standard has been reconfirmed in Australia in 2015 and remains current in New Zealand. Reconfirmation Notice 23/04/2015 |
| Committee | WS-022 |
| Supersedes |
|
