Plastics - Glass filament reinforced plastics (GRP) - Methods of test Determination of the dimensions of glass filament reinforced plastics pipes
Standards Australia
Reconfirmed 18/11/2016.
This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand.
RECONFIRMATION NOTICE
Technical Committee PL-044 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 13 October 2016.
The following are represented on Technical Committee PL-044:
Association of Accredited Certification Bodies
Business New Zealand
Composites Australia
Engineers Australia
Plastics Industry Pipe Association of Australia
Water Industry Alliance
Water Services Association of Australia
This Standard sets out a method for determining the dimensions of glass filament reinforced
plastics pipes, i.e. outside diameter, wall thickness, length, inside diameter and squareness
of pipe ends.
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 18/11/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 18/11/2016 |
| Committee | PL-044 |
| Supersedes |
|
