Household and similar electrical appliances - Safety Particular requirements for flexible sheet heating elements for room heating (IEC 60335-2-96:2002, IDT)
Standards Australia
RECONFIRMATION NOTICE
Technical Committee EL-002 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 28 April 2016.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 18 May 2016.
The following are represented on Technical Committee EL-002:
Australian Industry Group
Australian Retailers Association
Business New Zealand
Consumer Electronics Suppliers Association
Consumers Federation of Australia
Electrical Regulatory Authorities Council
Engineers Australia
Joint Accreditation System of Australia and New Zealand
New Zealand Electric Fence Energiser Manufacturers Standards WG
NSW Fair Trading
Testing Interests (New Zealand)
Worksafe New Zealand
This clause of Part 1 is replaced by the following.
This International Standard deals with the safety of flexible sheet heating elements intended to be incorporated into the building to heat the room in which they are located, their rated voltage being not more than 250 V for single-phase installations and 480 V for other installations.
Flexible sheet heating elements are converted into heating units that are incorporated in the building in accordance with the instructions after which the required level of protection against hazards is achieved.
NOTE 101 Attention is drawn to the fact that
– in many countries different wiring rules apply;
– for heating units intended to be used in vehicles or on board ships or aircraft, additional requirements may be necessary;
– in many countries additional requirements are specified by the national authorities for fire protection, the national authorities for building regulations, the national health authorities, the national authorities responsible for the protection of labour and similar authorities.
NOTE 102 This standard does not apply to
– heating units intended exclusively for industrial purposes;
– heating units intended to be used in locations where special conditions prevail, such as the presence of a corrosive or explosive atmosphere (dust, vapour or gas);
– blankets, pads and similar flexible heating appliances (IEC 60335-2-17);
– heated mats and foot warmers (IEC 60335-2-81);
– heating appliances intended to be used under a carpet;
– flexible heating elements incorporated in other appliances.
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 30/09/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 30/09/2016 |
| Committee | EL-002 |
| Under Revision |
|
| Supersedes |
|
