AS/NZS 2276.3:2002 (R2017)
AS/NZS 2276.3:2002 (R2017)
Cables for traffic signal installations Loop cables for vehicle detectors
Standards Australia
Table of Contents
Abstract
Specifies the requirements for single core cables intended for the construction of inductive vehicle-detector loops for traffic signal installations, suitable for installation in slots cut into road surfaces.
RECONFIRMATION NOTICE
Technical Committee EL-003 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 10 October 2016.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 13 December 2016.
The following are represented on Technical Committee EL-003:
Australian Cable Makers' Association
Australian Industry Group
Electrical Compliance Testing Association
Electrical Regulatory Authorities Council
National Electrical and Communications Association
Queensland University of Technology
Scope
This Standard specifies requirements for single-core cable intended for the construction of
inductive vehicle-detector loops for traffic signal installations operating in the frequency
range 20 kHz to 200 kHz, and suitable for installation in slots cut into the road surface, the
slots being subsequently filled with a suitable sealant.
The cable is intended for operation in extra-low voltage (ELV) circuits and may be
accommodated in unsegregated cable enclosures together with low voltage (LV) cables.
NOTE: Purchasing guidelines are given in Appendix A.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 20/01/2017. This standard has been reconfirmed in Australia in 2017 and remains current in New Zealand. Reconfirmation Notice 20/01/2017 |
| Committee | EL-003 |
| Supersedes |
|
