Fire detection, warning, control and intercom systems - Methods of test Heat sensitivity testing of Type E heat detectors
Standards Australia
RECONFIRMATION NOTICE
Technical Committee FP-002 has reviewed the content of this publication and in
accordance with Standards Australia procedures for reconfirmation, it has been
determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the
original date of publication. Users are advised to ensure that they are using the latest
versions of such documents as appropriate, unless advised otherwise in this
Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 16 June 2016.
The following are represented on Technical Committee FP-002:
Association of Hydraulic Services Consultants Australia
Australasian Fire and Emergency Service Authorities Council
Australian Building Codes Board
Australian Chamber of Commerce and Industry
Australian Industry Group
Australian Institute of Building Surveyors
CSIRO
Deafness Forum of Australia
Department of Human Services (VIC)
Engineers Australia
Fire Protection Association Australia
National Electrical and Communications Association
National Fire Industry Association
Property Council of Australia
Society of Fire Safety
This Standard sets out the method for determining the alarm state temperature of a Type E heat detector. (See performance requirement in the appropriate device Standard.)
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 08/07/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 08/07/2016 |
| Committee | FP-002 |
| Supersedes |
|
