AS/NZS 1301.001s:2002 (R2013)

Table of Contents

1 -  AS/NZS 1301.001s:2002 METHODS OF TEST FOR PULP AND PAPER - BASIC DENSITY OF PULPWOOD
4 -  Contents
5 -  Foreword
6 -  Introduction
7 -  1 Scope
7 -  2 Normative references
7 -  3 Principle
7 -  4 Apparatus
7 -  4.1 Balance
7 -  4.2 A ventilated drying oven
7 -  4.3 Chip basket
7 -  4.4 A laboratory screen
7 -  4.5 Towels
7 -  4.6 Container
7 -  4.7 Auxiliary apparatus
7 -  5 Test specimens
8 -  6 Procedure
8 -  6.1 Determination of soaked volume
8 -  6.1.1 Soaking
8 -  6.1.2 Draining
8 -  6.1.3 Volume determination
10 -  6.2 Determination of oven dry mass
10 -  7 Calculation
10 -  8 Apparatus
10 -  8.1 Balance
10 -  8.2 Container
10 -  8.3 Holding clamps
10 -  8.4 Submerging weights (optional)
10 -  8.5 A ventilated drying oven
10 -  8.6 Drying rack
10 -  8.7 Saw
10 -  8.8 Towels
10 -  9 Sampling
11 -  10 Test specimens
11 -  11 Procedure
11 -  11.1 Determination of soaked volume
11 -  11.1.1 Soaking
11 -  11.1.2 Draining
11 -  11.1.3 Volume determination
12 -  11.2 Determination of oven-dry mass
12 -  12 Calculation
12 -  13 Report
14 -  Annex A - Bibliography

Abstract

RECONFIRMATION NOTICE
Technical Committee PK-019 has reviewed the content of this publication and in
accordance with Standards Australia procedures for reconfirmation, it has been determined
that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original
date of publication. Users are advised to ensure that they are using the latest versions of
such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 13 September 2013.
The following are represented on Technical Committee PK-019:
Appita
Australian Forest Products Association
Australian Institute of Packaging
HRL Technology

Scope

This standard prescribes the procedures to be used for determining basic density of pulpwood either in chip or disk form.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	This standard has been reconfirmed in Australia in 2013 and remains current in New Zealand. Reconfirmation Notice 11-12-2013
Pages
ISBN
Committee	PK-019
Supersedes	DR 98352 CP AS 1301.P1s-1979 DR 98352-98354 CP