AS/NZS 60745.1:2003

Table of Contents

Abstract

Specifies general safety requirements for hand-held motor-operated electric tools. It is a base Standard which, when combined with a particular Standard in the AS/NZS 60745 series, becomes a complete Standard for the particular hand-held motor-operated tool. This Standard is technically equivalent to and has been reproduced from IEC 60745-1:2001.

Scope

1.1 This International Standard deals with the safety of hand-held motor-operated or magnetically driven electric tools, the rated voltage of the tools being not more than 250 V for single-phase a.c. or d.c. tools, and 440 V for three-phase a.c. tools.
So far as is practicable, this standard deals with the common hazards presented by hand-held tools, which are encountered by all persons in the common use of the tools.
Tools with an electric heating element are within the scope of this standard. They should also comply with relevant parts of IEC 60335.
Hand-held electric tools, hereinafter referred to as tools, which can be mounted on a support for use as fixed tools without any alteration of the tool itself, are within the scope of this standard. Unless the requirement for such support is given in a relevant part 2, this standard alone will not be sufficient to ensure that the combination of tool and support is adequate.
Requirements for motors not isolated from the supply, and having basic insulation not designed for the rated voltage of the tools, are given in Annex B.
This standard does not apply to:
– hand-held tools intended to be used in the presence of explosive atmosphere (dust, vapour or gas);
– hand-held tools used for preparing and processing food;
– hand-held tools for medical purposes (IEC 60601);
– heating tools which are covered by IEC 60335-2-45.
For hand-held tools intended to be used in vehicles or on board ships or aircraft, additional requirements may be necessary. NOTE Attention is drawn to the fact that in many countries, additional requirements are specified by the national health authorities, the national authorities responsible for the protection of labour, the national water supply authorities, etc.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	EL-002
Under Revision	DR 07917 CP DR 08984 CP DR 03946 DR 03926
Supersedes	DR 02915 AS/NZS 7450.1:1999
Superseded By	AS/NZS 60745.1:2009