Safety requirements for electrical equipment for measurement, control and laboratory use - Particular requirements for hand-held and hand-manipulated current sensors for electrical test and measurement
Standards Australia
Specifies particular requirements for hand-held current sensors for electrical test and measurement. This Standard is reproduced from IEC 61010-2-032:2002.
RECONFIRMATION NOTICE
Technical Committee EL-049 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 03 September 2015.
The following are represented on Technical Committee EL-049:
Australian Chamber of Commerce and Industry
Bureau of Steel Manufacturers of Australia
Electrical Compliance Testing Association
This clause of part 1 is applicable, except as follows:
1.1 Scope
Replacement:
This Standard applies to the HAND-HELD and hand-manipulated CURRENT SENSORS described below. These CURRENT SENSORS are for use in the measurement of current without physically opening the current path of the circuit being measured. They may be stand-alone CURRENT SENSORS or accessories to other equipment.
CURRENT SENSORS require hand manipulation before or after a test or measurement, but do not necessarily need to be HAND-HELD during the test or measurement.
Type A CURRENT SENSOR: a CURRENT SENSOR designed to be applied around or removed from uninsulated HAZARDOUS LIVE conductors. Type A CURRENT SENSORS have defined HAND-HELD or hand-manipulated parts providing protection against electric shock from the conductor being measured, and also have protection against short-circuits between wires and busbars during clamping.
Type B CURRENT SENSOR: a CURRENT SENSOR which has protection against a short-circuit between wires or busbars during clamping but without defined HAND-HELD or hand-manipulated parts which provide protection against electric shock during clamping. Additional protective means are necessary to avoid electric shock from HAZARDOUS LIVE conductors which cannot be de-energised during application or removal of the CURRENT SENSOR.
NOTE Type B CURRENT SENSORS include flexible CURRENT SENSORS.
Type C CURRENT SENSOR: a CURRENT SENSOR without protection against short-circuits between wires or busbars during clamping. Type C CURRENT SENSORS are intended to be applied to or removed from uninsulated HAZARDOUS LIVE conductors only when they are de-energised.
NOTE Type C CURRENT SENSORS include some types of split-core transducers.
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 20/05/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 20/05/2016 |
| Committee | EL-049 |
| Supersedes |
|
