Categories

AS 1910-2004 (R2016)

AS 1910-2004 (R2016)

Water supply - Float control valves for use in hot and cold water

Standards Australia

More details

Download

PDF AVAILABLE FORMATS IMMEDIATE DOWNLOAD
$34.32

$78.00

(price reduced by 56 %)

Table of Contents

Abstract

RECONFIRMATION NOTICE
Technical Committee WS-001 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 3 September 2015.
The following are represented on Technical Committee WS-001:
Association of Accredited Certification Bodies
Australian Industry Group
Building Officials Institute of New Zealand
CSIRO
Gas Technical Regulators Committee
Housing Industry Association
National Association of Testing Authorities Australia
Plastics Industry Pipe Association of Australia
Plastics New Zealand
Plumbing Distributors Association of New Zealand
Plumbing Products Industry Group
Queensland Brassware Association
The Institute of Plumbing Australia
Water Services Association of Australia

Scope

This Standard specifies requirements for active float control valves for use in water supply systems where the normal working temperature does not exceed 95°C and the continuous working pressure extends up to a maximum of 1.4 MPa for a range of nominal sizes from DN 6 to DN 80.
This Standard does not cover WC cistern flushing valves.
NOTE: WC cistern flushing valves are covered in all parts of AS 1172.
Means of demonstrating compliance with this Standard are set out in Appendix A.

General Product Information

Document Type Standard
Status Current
Publisher Standards Australia
ProductNote Reconfirmed 03/06/2016.
This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 03/06/2016
Committee WS-001
Under Revision
  • DR 06072 CP
Supersedes
  • DR 03484
  • AS 1910-1994

Contact us