AS 1101.3-2005 (R2018)
AS 1101.3-2005 (R2018)
Graphical symbols for general engineering Welding and non-destructive examination
Standards Australia
Abstract
Specifies symbols that provide the means of placing complete welding information on drawings. It describes the application of these symbols and includes illustrated examples for their use in various welding processes. A separate section covers the symbols to be used on drawings to specify non-destructive examination requirements.
RECONFIRMATION NOTICE
Major stakeholders of this publication have reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 12 January 2018.
Scope
This Standard describes symbols that provide the means of placing complete welding information on drawings. It covers the details of symbols and requirements for their application in various welding processes (including brazing), and non-destructive examination.
NOTE: Appendix A gives a listing of abbreviations normally used for welding and allied processes.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 16/03/2018. This standard has been reconfirmed in Australia in 2018 and remains current in New Zealand. Reconfirmation Notice 16/03/2018 |
| Committee | WD-001 |
| Supersedes |
|
