AS ISO 128.20-2005 (R2016)
AS ISO 128.20-2005 (R2016)
Technical drawings - General principles of presentation Basic conventions for lines
Standards Australia
Table of Contents
Abstract
Specifies the type of lines, designations and configuration as well as general rules for drafting of lines used in technical drawings.
RECONFIRMATION NOTICE
Technical Committee ME-072 has reviewed the content of this publication and in
accordance with Standards Australia procedures for reconfirmation, it has been
determined that the publication is still valid and does not require change.
Reconfirmed documents cannot be amended, but may be formally revised and a new
edition published.
Certain documents referenced in the publication may have been amended since the
original date of publication. Users are advised to ensure that they are using the latest
versions of such documents as appropriate, unless advised otherwise in this
Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 23 December 2015.
The following are represented on Technical Committee ME-072:
Australian Institute of Architects
Department for Education and Child Development (SA)
Design Association of New Zealand
Engineers Australia
TAFE NSW
The University of Adelaide
The University of New South Wales
University of South Australia
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 15/04/2016 This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 15/04/2016 |
| Committee | ME-072 |
| Supersedes |
|
