AS 4628-2005 (R2018)
AS 4628-2005 (R2018)
Pressure and temperature limit devices for use with gas burners
Standards Australia
Abstract
Specifies the uniform minimum requirements for manufacturers, designers, regulatory authorities, testing laboratories and similar organizations for the safety, performance and use of pressure and temperature limit devices for use with gas burners. These pressure and temperature limit devices are intended for use with natural gas, town gas, tempered liquefied petroleum gas and liquefied petroleum gas.
RECONFIRMATION NOTICE
Technical Committee AG-013 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 25 January 2018.
The following are represented on Technical Committee AG-013:
Association of Accredited Certification Bodies
Australian Industry Group
Energy Networks Australia
Engineers Australia
Gas Appliance Manufacturers Association of Australia
Gas Association of New Zealand
Gas Energy Australia
Gas Technical Regulators Committee
LPG Association of New Zealand
Master Plumbers and Mechanical Services Association of Australia (Victorian)
National Association of Testing Authorities Australia
Scope
These requirements apply to pressure and temperature limit devices intended to be used with gas or multi-fuel burners.
Compliance with these requirements does not imply acceptability for use without supplemental tests in an intended application.
A limit device incorporating electrical components shall comply with the requirements of the appropriate electrical authority.
Requirements for mechanically operated over-pressure and under-pressure cut-off devices are published in AS 4632.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 23/02/2018. This standard has been reconfirmed in Australia in 2018 and remains current in New Zealand. Reconfirmation Notice 23/02/2018 |
| Committee | AG-011 |
| Under Revision |
|
| Supersedes |
|
