AS 62061-2006

Table of Contents

Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviations
3.1 Alphabetical list of definitions
3.2 Terms and definitions
3.3 Abbreviations
4 Management of functional safety
4.1 Objective
4.2 Requirements
5 Requirements for the specification of Safety-Related
Control Functions (SRCFs)
5.1 Objective
5.2 Specification of requirements for SRCFs
6 Design and integration of the safety-related electrical
control system (SRECS)
6.1 Objective
6.2 General requirements
6.3 Requirements for behaviour (of the SRECS) on
detection of a fault in the SRECS
6.4 Requirements for systematic safety integrity of
the SRECS
6.5 Selection of safety-related electrical control
system
6.6 Safety-related electrical control system (SRECS)
design and development
6.7 Realisation of subsystems
6.8 Realisation of diagnostic functions
6.9 Hardware implementation of the SRECS
6.10 Software safety requirements specification
6.11 Software design and development
6.12 Safety-related electrical control system integration
and testing
6.13 SRECS installation
7 Information for use of the SRECS
7.1 Objective
7.2 Documentation for installation, use and maintenance
8 Validation of the safety-related electrical control
system
8.1 Objective
8.2 General requirements
8.3 Validation of SRECS systematic safety integrity
9 Modification
9.1 Objective
9.2 This Clause specifies the modification procedure(s)
to be applied when modifying the SRECS during design,
integration and validation (e.g. during SRECS
installation and commissioning). Modification
procedure
9.3 Configuration management procedures
10 Documentation
Annex A (informative) SIL assignment
Annex B (informative) Example of safety-related electrical
control system (SRECS) design using concepts and
requirements of Clauses 5 and 6
Annex C (informative) Guide to embedded software design
and development
Annex D (informative) Failure modes of electrical/electronic
components
Annex E (informative) Electromagnetic (EM) phenomenon
and increased immunity levels for SRECS intended
for use in an industrial environment according to
IEC 61000-6-2
Annex F (informative) Methodology for the estimation of
susceptibility to common cause failures (CCF)

Abstract

Provides requirements and makes recommendations for the specification, design and validation of safety-related electrical control systems for machines. It is applicable to control systems used, either singly or in combination, to carry out safety-related control functions on machines that are not portable by hand, (including groups of machines working together in a coordinated manner).

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Pending Revision indicates that as a result of the Aged Standards review process, the document needs updating. If no project proposal, meeting the quality criteria, is received within the 12 month timeframe, the document shall be withdrawn.
Pages
ISBN
Committee	EL-017
Supersedes	DR 06015 CP