AS/NZS 4680:2006 (R2017)
AS/NZS 4680:2006 (R2017)
Hot-dip galvanized (zinc) coatings on fabricated ferrous articles
Standards Australia
Abstract
Specifies requirements and tests for hot-dip zinc coatings on fabrications, assembled steel products, tubular fabrications, fabricated wire work, steel forgings, steel stampings, ferrous castings, nails and small components.
RECONFIRMATION NOTICE
Technical Committee MT-009 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 20 March 2017.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 10 August 2017.
The following are represented on Technical Committee MT-009:
Australian Chamber of Commerce and Industry
Australian Industry Group
Australian Steel Institute
Bureau of Steel Manufacturers of Australia
Galvanizers Association of Australia
Galvanizing Association of New Zealand
New Zealand Metal Roofing Manufacturers
Scope
This Standard specifies requirements and tests for hot-dip zinc coatings on fabricated ferrous articles including structural steel, steel reinforcements, steel sheet fabrications, assembled steel products, tubular fabrications, fabricated wire work, steel forgings, steel stampings, ferrous castings, nails and other small components.
This Standard applies to both centrifuged and non-centrifuged articles.
This Standard does not apply to products such as wire and welded wire fabric (see AS/NZS 4534), sheet (see AS 1397) or open sections (see AS/NZS 4791) and tube hot-dip galvanized in continuous, semi-continuous or specialized plants (see AS/NZS 4792).
NOTES:
1 Advice and recommendations on information to be supplied by the purchaser to the hot-dip galvanizer at the time of enquiry or order are contained in the purchasing guidelines set out in Appendix A.
2 Means for demonstrating compliance with this Standard are given in Appendix B.
3 After-treatment of hot-dip galvanized articles is not covered by this Standard. Such treatment (if any) should be specified separately by the purchaser.
General Product Information
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 29/09/2017. This standard has been reconfirmed in Australia in 2017 and remains current in New Zealand. Reconfirmation Notice 29/09/2017 |
| Committee | MT-009 |
| Supersedes |
|
