AS/NZS 2270:2006 (R2016)

Table of Contents

Abstract

Provides minimum performance requirements and specifications for appearance and non-appearance grades of plywood and blockboard acceptable for use in fully protected interior applications in Australia and New Zealand. Describes the basic interior plywood and blockboard product. Particular end uses may require additional processing, immunization or surface finishing.
RECONFIRMATION NOTICE
Technical Committee TM-011 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 27 April 2016.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 18 May 2016.
The following are represented on Technical Committee TM-011:
Australian Building Codes Board
Australian Forest Products Association
Australian Timber Importers Federation
Australian Wood Panels Association
Building Research Association of New Zealand
Engineered Wood Products Association of Australasia
Forest and Wood Products Australia
Furntech-AFRDI
Glued Laminated Timber Association of Australia
Master Builders Australia
Monash University
New Zealand Plywood Manufacturers Association
New Zealand Timber Industry Federation
Timber Design Society
Wood Processors & Manufacturers Association of New Zealand

Scope

This Standard specifies requirements for the manufacture, grading and finishing of plywood and blockboard used in non-structural interior applications where the product is fully protected from the weather, or wet or damp conditions. It also specifies veneer and core strip qualities, bond quality, joints, panel construction, dimensional tolerances, moisture content, finishing and branding.
Two bond types are specified, i.e., types C and D, which are suitable for interior applications only.
NOTES:
1 Exposure conditions are defined in AS 2754.1.
2 Requirements for the Type C and D bond durability tests are specified in AS/NZS 2098.2.
3 Appendix A provides the information to be supplied with inquiries and orders.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 07/10/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 7/10/2016
Pages
ISBN
Committee	TM-008
Supersedes	DR 06375 AS/NZS 2270:1999