Methods of testing portland, blended and masonry cements Acid soluble calcium oxide content of blended cement
Standards Australia
RECONFIRMATION NOTICE
Technical Committee BD-010 has reviewed the content of this publication and in
accordance with Standards Australia procedures for reconfirmation, it has been
determined that the publication is still valid and does not require change.
Reconfirmed documents cannot be amended, but may be formally revised and a new
edition published.
Certain documents referenced in the publication may have been amended since the
original date of publication. Users are advised to ensure that they are using the latest
versions of such documents as appropriate, unless advised otherwise in this
Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for
reconfirmation on 24 February 2016.
The following are represented on Technical Committee BD-010:
AUSTROADS
Cement & Concrete Association of New Zealand
Cement Concrete & Aggregates Australia
Cement Concrete & Aggregates Australia – Cement
Cement Concrete & Aggregates Australia – Concrete
Concrete Institute of Australia
Concrete Masonry Association of Australia
Engineers Australia
Portland Cement Association
This Standard sets out the reference method for determining the acid soluble calcium oxide of blended cement and its constituents.
Where test results are to be used to calculate the proportions of blended cement, the same procedure, referee or alternate, should be used for analysis of the constituents and the blended cement.
The testing procedure herein may involve the use of materials or equipment that require safety measures to be observed.
This Standard does not purport to address all of the safety concerns, if any, associated with its use.
The user of this Standard should establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 15/04/2016 This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 15/04/2016 |
| Committee | BD-010 |
| Supersedes |
|
