AS 62217-2007

Table of Contents

1 -  AS 62217-2007 Polymeric insulators for indoor and outdoor use with a nominal voltage > 1000 V„General definitions, test metho
4 -  PREFACE
5 -  CONTENTS
6 -  INTRODUCTION
7 -  1 Scope and object
7 -  2 Normative references
8 -  3 Terms and definitions
10 -  4 Identification
10 -  5 Environmental conditions
11 -  6 Information on transport, storage and installation
11 -  7 Classification of tests
11 -  7.1 Design tests
12 -  7.2 Type tests
12 -  7.3 Sample tests
12 -  7.4 Routine tests
12 -  8 General requirements for insulator test specimens
13 -  9 Design tests
13 -  9.1 General
13 -  9.2 Tests on interfaces and connections of end fittings
15 -  9.3 Tests on shed and housing material
18 -  9.4 Tests on the core material
23 -  Annex A (normative) Wheel test
23 -  A.1 Test specimens
23 -  A.2 Procedure
23 -  A.3 Test conditions
23 -  A.4 Acceptance criteria
25 -  Annex B (normative) Test at multiple stresses
25 -  B.1 Test specimen
25 -  B.2 Procedure
26 -  B.3 Test conditions
27 -  B.4 Salt fog calibration
28 -  B.5 Acceptance criteria
31 -  Annex C (informative) Difference between the tracking and erosion and accelerated ageing tests on polymeric insulators
32 -  Annex D (informative) Recommended application of tests
33 -  Annex E (informative) Explanation of the concept of classes for the design tests
34 -  Bibliography

Abstract

Specifies common requirements for polymeric insulator for use on overhead lines

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Pending Revision indicates that as a result of the Aged Standards review process, the document needs updating. If no project proposal, meeting the quality criteria, is received within the 12 month timeframe, the document shall be withdrawn.
Pages
ISBN
Committee	EL-010
Supersedes	DR 07010 CP