AS 2944.2-2007

Table of Contents

1 -  AS 2944.2-2007 PLASTICS PIPES AND FITTINGS FOR GAS RETICULATION - POLYAMIDE FITTINGS
4 -  PREFACE
5 -  CONTENTS
6 -  1 SCOPE
6 -  2 APPLICATION
6 -  3 REFERENCED DOCUMENTS
6 -  4 NOTATION
6 -  5 CLASSIFICATION
7 -  6 COMPOSITION
7 -  7 FREEDOM FROM DEFECTS
7 -  8 DIAMETER, WALL THICKNESS AND LENGTH
7 -  9 TEST REQUIREMENTS
7 -  9.1 Resistance to internal pressure at elevated temperature
7 -  10 MARKING
9 -  APPENDIX A - MEANS FOR DEMONSTRATING COMPLIANCE WITH THIS STANDARD
9 -  A1 SCOPE
9 -  A2 RELEVANCE
9 -  A3 DEFINITIONS
9 -  A3.1 Acceptable quality level (AQL)
9 -  A3.2 Batch
9 -  A3.3 Batch release test (BRT)
9 -  A3.4 Inspection level
9 -  A3.5 Lot
9 -  A3.6 New formulation
9 -  A3.7 Process verification test (PVT)
10 -  A3.8 Sample
10 -  A3.9 Sampling plan
10 -  A3.10 Type test (TT)
10 -  A4 PRODUCT CERTIFICATION
10 -  A5 MINIMUM SAMPLING AND TESTING FREQUENCY PLAN
10 -  A5.1 General
10 -  A5.2 Retesting
10 -  A5.3 Rejection after test

Abstract

Specifies requirements for moulded polyamide external fittings for use with polyamide gas pipe, suitable for operation at pressures up to and including 400 kPa.

Scope

This Standard specifies requirements for moulded polyamide external fittings for use with polyamide gas pipe, suitable for operation at pressures up to and including 400 kPa.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	PL-021
Supersedes	AS 2944.2-1987 DR 05469 AS 2944 (Pt 1 to 2)-1987