AS 681.1-2008

Table of Contents

1 -  AS 681.1-2008 Elastomeric seals-Material requirements for pipe joint seals used in water and drainage applications - Part 1: Vulcanized rubber
4 -  PREFACE
6 -  INTRODUCTION
7 -  CONTENTS
9 -  1 Scope
9 -  2 Normative references
10 -  3 Classification
10 -  4 Requirements
13 -  5 Test pieces and temperature
13 -  6 Factory production control
13 -  7 Factory product control test
14 -  8 Storage
14 -  9 Designation
14 -  10 Marking and labelling
18 -  Annex A (normative) Determination of stress relaxation in tension
20 -  Annex B (normative) Determination of compression set in hot water at 110°C
21 -  Annex C (normative) Determination of splice strength
21 -  Annex D (informative) Guidance on storage of seals
22 -  Annex ZA (informative) Clauses of this European Standard addressing the provisions of the EU Construction Products Directive

Abstract

Specifies requirements for materials used in vulcanized rubber seals for cold potable water supply (up to 50°C), hot potable and non-potable water supply (up to 110°C), and drainage, sewerage and rainwater systems (continuous flow up to 45°C and intermittent flow up to 95°C).

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	WS-010
Supersedes	DR 06711 CP