Methods for preparation and testing of stabilized materials Sampling - Preparation of stabilized pavement materials
Standards Australia
<toc />
RECONFIRMATION NOTICE
Technical Committee CE-009 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 20 January 2017.
The following are represented on Technical Committee CE-009:
Association of Geotechnical Testing Authorities (Qld)
Australian Building Codes Board
Australian Chamber of Commerce and Industry
Australian Geomechanics Society
Australian Stabilisation Industry Association
AUSTROADS
Cement Concrete & Aggregates Australia – Aggregates
Engineering & Construction Laboratories Association
Engineers Australia
National Association of Testing Authorities Australia
The University of Melbourne
The University of Sydney
Victorian Construction Materials Laboratories Association
This Standard sets out the method for the addition in the laboratory of cementitious stabilizing binders such as lime, blended lime mixtures, cement, blended cements, bituminous or other materials to soils, gravels and crushed rock pavement materials, in preparation for use in an appropriate test method.
The size fraction of the material to be prepared will depend on the test to be performed on the stabilized material. For unconfined compressive strength tests and California bearing ratio tests, the fraction used has to be that passing the 19.0 mm sieve.
NOTE: The binders usually used for stabilized pavements are covered by the following Standards:
(a) Limes, AS 1672.1.
(b) Cements, AS 3972.
(c) Bitumens, AS 1160 and AS 2157.
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 17/03/2017. This standard has been reconfirmed in Australia in 2017 and remains current in New Zealand. Reconfirmation Notice 17/03/2017 |
| Committee | CE-009 |
| Supersedes |
|
