AS 1548-2008 (R2018)

Abstract

Specifies requirements for hot-rolled, fine grained, fully killed carbon manganese steel plates to a maximum thickness of 150 mm for use in the construction of pressure equipment.

RECONFIRMATION NOTICE
Technical Committee ME-001 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 26 March 2018.
The following are represented on Technical Committee ME-001:
Australasian Corrosion Association
Australasian Institute of Engineer Surveyors Australian Aluminium Council
Australian Building Codes Board
Australian Chamber of Commerce and Industry Australian Industry Group
Australian Institute for Non-Destructive Testing Australian Institute for the Certification of Inspection Personnel
Australian Institute of Petroleum Ltd
Bureau of Steel Manufacturers of Australia Compressed Air Association of Australasia Department of Justice and Attorney General (QLD) Electricity Engineers Association (New Zealand) Energy Networks Australia
Engineers Australia
Gas Energy Australia
Institution of Professional Engineers New Zealand Insurance Council of Australia Limited
Materials Australia
National Association of Testing Authorities Australia
New Zealand Heavy Engineering Research Association
New Zealand Manufacturers and Exporters Association
Welding Technology Institute of Australia WorkSafe Division - Department of Mines, Industry Regulation and Safety (DMIRS) WA
WorkSafe Victoria

Scope

This Standard specifies requirements for hot-rolled, fine grained, fully killed carbon-manganese steel plates to a maximum thickness of 150 mm for use in the construction of pressure equipment.
NOTE: Guidelines to purchasers on requirements that should be specified by the purchaser and those that should be agreed to at the time of enquiry or order, or both, are given in Appendix A.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
ProductNote	Reconfirmed 20/04/2018. This standard has been reconfirmed in Australia in 2018 and remains current in New Zealand. Reconfirmation Notice 20/04/2018
Pages
ISBN
Committee	ME-001
Supersedes	DR 07147 AS 1548-1995