BS ISO 3384-1:2019
BS ISO 3384-1:2019 Rubber, vulcanized or thermoplastic. Determination of stress relaxation in compression. Testing at constant temperature
standard by British Standard / International Organization for Standardization, 08/19/2019
Full Description
WARNING 1 Persons using this document should be familiar with normal laboratory practice. This document does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user to establish appropriate safety and health practices and to determine the applicability of any other restrictions.WARNING 2 Certain procedures specified in this document might involve the use or generation of substances, or the generation of waste, that could constitute a local environmental hazard. Reference should be made to appropriate documentation on safe handling and disposal after use.This document specifies two procedures for determining the decrease in counterforce exerted by a test piece of vulcanized or thermoplastic rubber which has been compressed to a constant deformation and maintained thus at a predetermined test temperature.The counterforce can be determined either by means of a continuous-measurement system or by a discontinuous-measurement one.Two test methods are specified, method A and method B. In method A the compression and all measurements of counterforce are made at test temperature and in method B the compression and all measurements of counterforce are made at standard laboratory temperature.Method A and method B do not give the same results, as in method B the shrinkage of the material from the test temperature to standard laboratory temperature is included in the result.Two forms of test piece are specified in this document: cylindrical test pieces and rings. Comparison of results is valid only when made on test pieces of similar size and shape.The use of ring test pieces is particularly suitable for the determination of stress relaxation in liquid environments.This document deals only with testing at constant ambient or elevated temperature. Testing at temperatures below standard laboratory temperature is not specified. The methods have been used for low?temperature testing, but their reliability under these conditions is not proven.Cross References:
ISO 23529:2016
ISO 37:2017
ISO 18899:2013
ISO 188:2011
ISO 3601-1:2012
ISO 1817
ISO 11346
ISO 4287
ISO/TR 9272
ISO 19983
All current amendments available at time of purchase are included with the purchase of this document.
