AS 1154.1-2009

Abstract

This Standard provides uses and manufacturers of insulators and conductor fittings for overhead power lines with definitions of terms, performance requirements, dimensions, test methods and acceptance criteria.

Scope

This Standard sets out performance and general requirements for insulator and conductor fittings (other than helical fittings, OPGW and ADSS fittings, which are covered in AS 1154.3) together with the critical dimensions for cast, forged or fabricated insulator fittings for use on overhead electric power lines using insulators with minimum failing loads of 70 kN, 120 kN and 160 kN.
Pulling eyes provided to assist installation and fittings for insulated service lines, aerial bundled cables and high-voltage covered conductors are not covered by this Standard.
Fittings for high-temperature conductors are not covered by this Standard.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	EL-010
Supersedes	DR 07133