AS 1397-2011

Abstract

Specifies requirements for continuously hot-dip metallic coated sheet steel and strip supplied in thicknesses up to and including 5.0 mm.

Scope

This Standard specifies requirements for continuously hot-dip metallic coated sheet steel and strip supplied in thicknesses up to and including 5.0 mm.
Requirements for product conformity to this Standard are given in Appendix B.
Requirements covered in this Standard are as follows:
Formability grades of steel.
Structural grades of steel.
Classes of zinc coating, including differential coatings.
Classes of zinc coating converted to zinc/iron alloy.
Classes of zinc/aluminium coatings.
Classes of zinc/aluminium/magnesium alloy coating.
Classes of aluminium/zinc alloy coating.
Classes of aluminium/zinc/magnesium alloy coating.
Surface finish.

Advice and recommendations on information to be supplied by the purchaser at the time of enquiry or order are contained in Appendix A.
The specified requirements apply to the full length and full width of the product supplied, unless otherwise indicated.
Within the description of the classes of coatings, the majority element present is listed first, followed by the next major element and followed by a third element if appropriate.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	MT-001
Supersedes	DR AS 1397