AS/NZS 4417.1:2012

Abstract

This standard specifies the requirements for the Regulatory Compliance Mark (RCM) and its placement on electrical and electronic equipment to indicate compliance with regulations applicable to aspects of the equipment as covered in Part 2 of this Standard.

Scope

This standard specifies the requirements for the Regulatory Compliance Mark (RCM) and its
placement on electrical and electronic equipment to indicate compliance with regulations
applicable to aspects of the equipment as covered in Part 2 of this Standard.
It is to be read in conjunction with ACMA Labelling Notices, RSM Compliance Notices and
electrical safety legislation applicable to electrical and electronic equipment in Australia
and New Zealand including Acts and Regulation as well as Equipment Safety Rules made under that legislation. Standard AS/NZS 4417.1 is also to be read in conjunction with AS/NZS 4417.2 and vice versa.
In the event of any inconsistency between these documents an Act will prevail over Regulations, which in turn prevail over Equipment Safety Rules. All of these will prevail over
AS/NZS 4417.1 and AS/NZS 4417.2 in this event.
NOTE: The RCM is a trademark owned by Australian and New Zealand regulators and its design and use are legally protected by registration in Australia and New Zealand.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	Standards Australia
Pages
ISBN
Committee	QR-012
Supersedes	DR 11908 AS/NZS 4417.1:2009